Anatek Blue Ring "Q" Meter - Fully Assembled

Description

The successor to the famous Bob Parker FBT/LOPT kit and companion to the
Blue ESR meter kit
. This Ring Tester
, built 100% in the USA
,
is fully assembled an inexpensive and effective way to test any high Q inductive component. It is especially useful for doing a quick check on flyback transformers, line output transformers and other inductive components like deflection yoke windings and SMPS transformers.
Full Anatek 1 year warranty on manufacturing defects.
A high Q factor is a characteristic of low loss inductive components. A shorted turn or coil will show no rings. A shorted FBT diode will show few or no rings. The Blue ring tester gives you a measure of the "Q" factor of a inductive component.
Features of the Blue Ring Tester :
Supplied fully assembled, calibrated and working!
Online Anatek Blue Ring
Datasheet
One foot leads made with super flexible test lead wire
and crocodile clips
Tests inductors in circuit and test leads are non-polarized
Easy-to-read, high brightness red, yellow and green LEDs display the Q of the device being tested
Simple operation for fast easy diagnosis of faulty inductive components.
Ideal for testing flyback transformers, Horizontal yoke coils, B+ coils, SMPS primary windings, Fluorescent ballast/chokes and any other type of coils that have an inductance value of > 0.3 uH.
Built in Silicon Valley California, USA
See a written
review
by Jestine Yong
Blue Ring Tester
Video #1
,
Video#2
and
Video #3
The LEDs on the left side show the Q of the device being tested. Essentially, the m
ore LED's light up => higher Q of the device under test.
No lights = Short circuit
Red
= Bad or low Q
Yellow
= Medium Q
Green
= Good or High Q
F
rom our Past Customers on the Web:
I'll tell you why I DO feel lucky, and that's having purchased from someone who still understands the meaning of customer service! That goes a long way in my book (well, if I had a book)" - Tod
"Thank you very much for the Blue ESR and Blue RT kits. They worked out very well and I can honestly highly recommend your kits. I am very impressed with the quality of your kits and the detail that you provided to make the assembly absolutely painless" - George
View a great
informational page
created by a satisfied customer - Don Lewis
View a
review
on a Ring Tester built based on the Anatek Design